HOME < QVF < Commercial < Ethanol Concentration
 
 
Complete separation of water-ethanol mixtures cannot be achieved by simple rectification because of the formation of an azeotrope.

At 1 bar the azeotrope, which boils at 78.2 °C, has a composition of 95.6% w/w ethanol.

The production of absolute alcohol (100%) requires a different technique.

Corning offer a system based on the well-proven method of azeotrope distillation.

The addition of a third substance, usually toluene, to the water-ethanol mixture increases the relative volatility of water and ethanol and makes the separation possible.

Water, ethanol and toluene from a ternary azeotrope, which boil at approximately 4 °C below pure ethanol. This azeotrope forms two phases, one rich in water and ethanol, the other in toluene.
By using two distillation columns, water-ethanol mixture may be separated to give substantially pure components. Figure 1 shows a basic flow diagram for the process.

The feed stream (1) is mixed (3) with the ternary azeotrope (2) leaving the top of the primary column. The two-phase mixture is then divided in the separator into a light, toluene rich phase (5) and a heavy , ethanol-water phase (4). The ethanol-water phase (4) is fed to the secondary column which produces the ethanol-water azeotrope, with traces of toluene, as tops product (6), and water as the bottoms product (7).

The distillate (6) from the secondary column is then mixed with the toluene phase (5) leaving the separator and is fed to the primary column (8). The primary column produces ternary azeotrope as the tops product (2) and absolute alcohol as the bottoms product (9).

The absolute alcohol has a water content not greater than 0.1% and toluene levels of 2% or less.